Detection Systems DS7060 Manual do Utilizador descarregar pdf (Página 18)

4/98

Page 18 Copyright  1997-98 Detection Systems, Inc. DS7060-AUS Reference Guide

• System Trouble:

This report is sent when a

control trouble condition occurs.

• System Trouble Restoral:

This report is sent

when all system trouble conditions restore.

• Exit Error: This report is sent if an exit error

occurs. An exit error occurs when an entry/exit

zone is still violated at the end of the exit delay. If

this happens, the entry delay will begin. If the

system is not disarmed before the entry delay

expires, an alarm report for the effected zone will

be sent and the Exit Error Report will be sent.

• Recent Closing: This report is sent, along with

any alarm reports, when there is an alarm within

the first five minutes after the system has been

armed.

• Comm. Failure Report: This report is sent after

the programmed number of communicator

attempts. Refer to Address 22 - Dial Attempts.

• Comm. Restore Report: This report is sent after

there has been a communicator failure. Retries will

occur after 30 minutes, then every 24 hours or

when a new event occurs. When the next

successful communicator attempt occurs, this

report will be included.

• Automatic Test Report: This report is sent at

fixed intervals determined by programming

Address 48 - Automatic Test Report Interval. By

default, the panel will send the first automatic

report 12 hours after the panel has been powered

up, and from that point on, it will follow the interval

selected by Address 48. The time before the first

Automatic test report is sent can be adjusted

between 1 and 24 hours after the panel has been

powered up by setting Address 49 - Hours to First

Auto Test Report.

• Communicator Test Report: This report is sent

as a result of initiating a Communicator Test, a PIN

+ [#] [8] [2] command sequence. Requires that

Addresses 37 “Account Code”, 38 “Phone # 1

Format” and 40 “Phone #1 be programmed.

• System Test: This report is sent when a system

test has been started using the [#] [8] [1] key

sequence.

• System Test Restoral: This report is sent when

the system test [#] [8] [1] has been completed or

has timed-out.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Detection Systems DS7060 Manual do Utilizador Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Detection Systems DS7060